マイクロバブルシャワー | ピュアブル

株式会社オーラテック

For those outside the U.S.
Instruction Manual

For proper use How to Maintain
the Jet Panel

Purebble II has an air intake port on the handle of the shower.
If there was no problem when the shower was first used, but water starts leaking from the air intake port during use as shown in the photo, it is a sign of maintenance.

ピュアブルⅡ メンテナンスのサイン
Main cause of water leaking from air inlet
This is caused by substances adhering to the filter inside the hose connection (at the screw) of the shower head, or by clogging of the holes in the jet panel due to calcium components in the water, etc.
Care Instructions
Remove the filter and clean it with a toothbrush.
To clean the jet panel, please follow the procedure below.*Remove the O-ring of the shower jet panel in advance.
Please be careful not to lose any parts when cleaning.
Caution
If water comes out of the air inlet, there is nothing blocking the screw part of the air inlet, so maintenance of the screw part is not necessary.
  1. 1.Items needed for cleaning
    1.Items needed for cleaning
    ① small dish,② baking soda,③ toothbrush, water ④ Micro interdental brush
    (If cleaning with baking soda does not improve backflow from the air inlet, please refer to *A.)
  2. 2.Sprinkle baking soda liberally over the entire surface.
    2.Sprinkle baking soda liberally over the entire surface.
  3. 3.Add a little water to the sprinkled baking soda and rub it with your fingers so that the dissolved, liquid baking soda enters the hole.
    3.Add a little water to the sprinkled baking soda and rub it with your fingers so that the dissolved, liquid baking soda enters the hole.
  4. 4.After allowing the baking soda to stand for 30 minutes, place the tip of a toothbrush in the hole and scrub from both sides.
    4.After allowing the baking soda to stand for 30 minutes, place the tip of a toothbrush in the hole and scrub from both sides.
  5. 4′Place the tip of the toothbrush in the hole and scrub from both sides.
    4′Place the tip of the toothbrush in the hole and scrub from both sides.
  6. 5.Rinse well with water and put the O-ring back in place.
    5.Rinse well with water and put the O-ring back in place.
  7. If the cleaning with baking soda no longer causes backflow from the air inlet, the maintanance is complete.
    After attaching the shower jet panel to the shower head, connect it to the shower hose and check if air is being sucked in from the air inlet.
    If there is no improvement, repeat the procedure from (2) several times. If the problem still persists, go to *A.
  8. *A Cleaning method with micro interdental brush
    Use a thin brush that can penetrate the hole if calcium components or other hardened substances are adhering to the surface. Do this carefully from the backside to avoid damaging the hole (Use a micro interdental brush with the tip cut off).